Special Coatings

Scope of use: upon drying and baking , the preparation creates a dark silver-grey, semi-polished vitreous surface. It gives the painted surfaces the characteristic more durable “glaze” patina.

Directions for use: upon thoroughly stirring up, apply the Briliant Dye uniformly using a brush on a cold, degreased and rust-free sub-base. After drying completely, you may make fire. After use, wash the brushes in hot water.

Scope of use: it serves for stove, heater and stovepipe coatings. Upon drying and baking, a light, silvergrey matte coating will be created. The silver dye is non-flammable and non-toxic.

Directions for use: before use, mix the Silver Dye well and apply it uniformly using a brush on a hot, dust-, grease- and rust-free stoves, stove-pipes, heaters and alike. Where necessary, repeat the coating after drying.

Spreading rate: 1 package (100 g) per 1 square meter

Scope of use: it is employed for surface finish and protection of stoves and heaters of all types, stovepipes, sheet-metal stacks and car exhaust pipes. It is applicable up to 700 degrees Centigrade of surface temperature of painted objects.

Directions for use: prior to application, dust off, degrease and remove rust from the surface to be painted. Mix the Silver Dye Extra well and apply evenly using a brush or a roller. To achieve a glossy, silvery surface repeat the coating after drying, where necessary.

Spreading rate: 1 package (220 g) per 2 to 3 square meters

Scope of use: concentrated silicone hydrophobic coating, which decreases the absorption rate, the dirt adherence, increases durability, protects against acid rains, and, improves porous silicate building material thermal insulation properties. It serves for spraying, painting or soaking the porous silicate materials such as plasters, concrete, gas silicate, asbestos-cement, burnt roofing, sandstone and alike, with which it combines chemically.

Directions for use: during application the diluted Lukofob solution soaks in porous sub-base, dries and creates a colourless thin layer with a highly hydrophobic effect, while preserving the original steam permeability. Dilution with water: 1:10 up to 1:15 in case of plasters, concrete, asbestos-cement, 1:20 up to 1:30 in case of burnt roofing - by spraying, 1:50 up to 1:75 in case of soaking. Apply on a dry and clean surface in such an amount, as long as the solution is absorbed by the material. The solution may not run down.

Spreading rate: 1 litre of application solution per 3 to 4 square m large area